Controll-A-Door S series Manuel d'instructions télécharger pdf (Page 13)

Track

Door

Track

Level

Door

Drilled holes

Structural member

Fig. 16

Fig. 15

Fig. 14

Fig. 13

Mounting on a Track Type Door

Step 5 - Determine Bracket Position

Open the door and ﬁnd the highest point of travel of a.

the top door panel.

Using a level, transfer this height to the wall above the b.

door (Fig. 13) and mark a line 60mm above it.

Determine the centre point on the wall above and on c.

top of the door. Then draw two (2) lines extending

21.5mm from each side of the centre point.(Fig. 14)

Step 6 - Mounting the Wall Bracket

Centre the bracket over the intersection of these two a.

lines. Mark centres for at least two holes (Fig. 14).

Ensure a solid mounting point is behind •

these holes.

Drill holes into the wall with an appropriate sized bit. b.

Secure bracket to the wall using: c.

IF CONCRETE OR BRICK - 10mm dynabolts.

IF TIMBER - wood screw #20 or equivalent

(minimum 50mm long).

WARNING: Make sure concrete, brick wall

or timber lintels are solid and sound so as to

form a secure mounting platform.

Step 7 - Attach the C-Rail to the Wall Bracket

Attach the C-Rail assembly to the wall bracket with the a.

90mm long clevis pin and secure with the supplied

snap pin (Fig. 15).

Leave the powerhead in its packing box for protection b.

during installation.

Step 8 - Securing the Powerhead to the Ceiling

Raise the powerhead from the packing box and a.

support it in the horizontal position with a step ladder

or support system above the door.

Open the garage door. Rest the opener on the open b.

door and use a scrap piece of wood to bring it to

horizontal level.

Line up the track perpendicular to the wall.c.

Secure the perforated angle (not supplied) to the d.

ceiling above where powerhead’s mounting holes will

be once fully installed. A representative mounting is

shown (Fig. 16).

Connect the powerhead to the ceiling mounted e.

perforated angle with M8x20mm screws and nuts.

Strips should not extend more than 18mm below

centre of powerhead mounting holes (Fig. 16).

For an alternative mounting option, go to Step 12.1

WARNING: The opener must be securely

fastened to structural supports, otherwise

opener failure may ensue causing serious

personal injury and/or property damage.

11mm

Diamond PD Power Drive : Instruction Manual

13Controll-A-Door

Diamond Instruction Manual

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Controll-A-Door S series Manuel d'instructions Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Controll-A-Door S series