Controll-A-Door P Diamond Manuel d'instructions Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 29
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
Step 9.1 - Door Closing Test
Ensure that the door is open.
Place a 40mm obstacle flat on the floor under the
middle of the garage door (Fig. 20).
Operate the door in the close direction; the door must
reverse on hitting the obstruction. The CLOSE LIMIT
LED flashes to indicate an obstruction while closing.
If the door fails to reverse, remove the obstacle and
reset the door travel limits as per Step 7 on page 12.
Place the 40mm obstacle on the floor under the
garage door and then re-test.
IMPORTANT NOTE: If the test fails again, there may be
a problem with your door or opener - put the opener into
manual operation, only operate the door by hand and
phone for service.
Step 9.2 - Door Opening Test
Ensure that the door is closed.
Operate the opener to open the door.
While the door is opening (approximately 1 metre off
the floor) hold the bottom edge of the door with your
hands. When a reasonable downward force is exerted,
the door should halt.
The OPEN LIMIT LED will flash to indicate an open
obstruction has been detected.
If the door fails to halt, operate the opener for five
cycles and then re-test. If the test fails again you will
need to call for service.
NOTE: Ensure the door opens and closes properly.
IMPORTANT NOTE - The safety system is
designed to prevent entrapment or serious
injury. It relies upon physical contact with
objects in the path of the door. The safety
system alone may not prevent cosmetic
damage to motor vehicles or property.
IMPORTANT NOTE: The use of Safety Infra-red Beams
(Part No 062153) is recommended on all installations of
automatic garage door openers
WARNING: Doors requiring over 400N of force
to move must have Safety Infra-red Beams fitted
for safety.
IMPORTANT NOTE - Permanently fix the
label warning against entrapment and manual
operation in a prominent place or near any
fixed controls After installation, ensure that
the mechanism is properly adjusted and that
the opener reverses when the door contacts a
40mm high object placed on the floor under
the garage door.
a.
b.
c.
d.
e.
a.
b.
c.
d.
e.
Safety Obstruction Force Test
Fig.20
Wood 40mm high
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
15Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Commentaires sur ces manuels

Pas de commentaire